Yamaha YP250 5GM2-AE1 2000 Service Manual page 33

Air filter case
1
Seat lock
2
Tensioner
3
Crankcase breather hose
4
Fuel sender
5
Throttle cable
6
Seat lock cable assembly
7
Panel
8
Footrest board
9
Radiator resorvoir tank breather
10
hose
Vacuum hose
11
Throttle position sensor lead
12
Seat lock
13
CABLE ROUTING
Auto choke lead
14
Brake hose assembly
15
A. C. magneto lead
16
Starter motor lead
17
Engine ground lead
18
Wireharness
19
A Don't turn the idle adjust screw,
when fix the hose.
B Route the gray seat lock outer
cable through the left side of
frame.
C Set the fuel tank sender lead and
sub lead.
23
SPEC
D Fasten the wireharness on the
frome with a band and the end of
band match the tank rail pipe
angle.
E Fix the seat lock cable along the
guide of panel.
F Fasten the wireharness on the
frame with a plastic clamp.
G Fasten the starter motor lead on
the fuel tank brocket with a plas-
tic locking tie.
H Route the starter relay lead to-
ward inside.
I Route the battery negative lead
toward inside.