Bostitch BT1855 Technical Data Manual page 7

UTILITY HOOK INSTALLATION (Fig 15-17)
These tools include an additional utility hook suitable for storage and temporary hanging of the tool.
Warning: Always disconnect tool from air supply before making adjustments or before attempting any part assembly or disassembly.
1. Make sure sequential trip mode is selected (See Trip Operation Mode above)
2. Depress the utility hook release button on the hook body (Fig 15)
3. Slide the utility hook into the hook attachment slot. (Fig 16)
4. Release the utility hook release button and check to ensure that the hook is locked in position. (Fig 17)
WARNING! Never use the utility hook with the contact mode.
HEX WRENCH STORAGE (Fig 18)
A hex wrench for servicing the nailer is stored within the belt hook. To remove the belt hook, push out the short end of the hex wrench
from the backside of the belt hook. Then grasp the hex wrench from the front of the belt hook and remove.
Repairs should only be carried out by the authorized agents of Bostitch or by other experts, giving due regard to the safety, operating
and maintenance instructions in the Safety and Operating Instruction Manual, this tool manual and in the Tool Technical Data.
Technical Data:
Please look for the technical data in the table marked ? at the front of this manual.
A Length mm.
B Height mm.
C Width mm.
D Weight Kg.
E Noise L , 1s, d
PA
F Noise L
WA
G Noise L , 1s, 1m
PA
H Vibration m/s
I P max Bar
J P min Bar
, 1s, d
2
K Air consumption per shot @ 5.6 Bar
L Activation type
M Summer lubricant
N Winter lubricant
O O-ring lubricant
P Fastener Name
Q Dimensions mm.
R Head/crown
S Magazine capacity
T New Driver Length mm.
U Max. Depth Inside Piston mm.