Fitting A New Door - Fisher & Paykel E522BRXU Supplemental Service Manual

517804 D
Turn guide 90º to door to remove guide from
housing
Remove hose from door conduit.
Fit harness to bullet supplied
with replacement door and
tape harness to bullet
Note this is required to pull the
harness through the conduit.
Ease bullet into conduit and
draw harness out of door.
Once the harness is removed from the door, remove the old door from the cabinet.
9.12

Fitting a new door

•
Fit the new door to cabinet.
From the harness RAST connector measure
300 mm (12 inches) and place a mark on the
harness.
The mark on the harness is to be placed in the
middle of the guide.
40