Key Silent Mode; Dispense Lock; Key Lock; Icemaker - Fisher & Paykel E522BRXU Supplemental Service Manual

517804 D
2.6.7

Dispense Lock

2.6.8

Key Lock

2.6.9 Filter Replacement Alert
3

ICEMAKER

3.1

Ice Production

The icemaker comes out of the factory defaulted to off. To turn the icemaker on, press the MENU button and
continue pressing the button until the ICE option has been scrolled to.
Press the UP and DOWN buttons to turn the icemaker on or off. When the cubes are frozen, the icemaker
motor will turn the ice cube tray and twist the tray causing the ice cubes to dislodge and fall out of tray. The
tray will then return to its normal position and refill with water.
Note: If the FC is above 32ºF or ice bin is full, or has been removed, or fitted the wrong way around, the
icemaker will not operate.
3.2

Information About The Icemaker

•
The temperature of the FC needs to reach 14ºF before the icemaker commences to operate.
•
When first switched on the icemaker carries out a harvest with no water in the ice tray.
•
Once the ice tray resumes its normal position the water will fill the tray. At this stage it will calculate the
amount of time taken to do a cycle and then flips. After this point it will run normally calculating the amount
of time for each batch. The rate of production will depend on the temperature of the freezer and will not
operate if the temperature is above 14º F.
NOTE: If the temperature is above 32ºF the ice/water tray will sit in this position and will not turn to
dispense.
•
The cubes will be ejected from the mould into the ice bin.
It is suggested that the ice cubes are levelled with the ice scoop occasionally for maximum storage.
•
The large and small freezer bins can be rotated if a large amount of ice is required.
3.3 To Manually Force Icemaker
(Products before January 2009)
Press and hold down the MEASURED FILL + UP + DOWN buttons for 4 seconds. This will activate the
icemaker. Note: if the bins are removed to observe the icemaker operation, the icemaker will start to rotate.
However, if the bin lever device is in a down position the icemaker will not rotate. The lever-lock needs to be
either removed or pushed backwards for the icemaker to complete a full rotation.
Water Dispense Key Lock - disables the water dispensing pad &
prevents water from being dispensed.
To activate this mode press the MENU and MEASURED FILL button
together for two (2) seconds.
Display Key Lock -disables all the buttons.
To activate this mode press the MENU and MEASURED FILL button
together after 4 seconds.
Filter Replacement Alert - this icon will appear when the water filter
needs changing. The filter needs replacing every 2800L or 6 months.
This will flash when dispensing water.
To deactivate the warning press the MEASURED FILL and UP buttons
for 4 seconds.
14