Related Manuals for KTI KS-516
Summary of Contents for KTI KS-516
- Page 1 Installation Guide 10/100 Fast Ethernet Switch KS-516 KS-524 P/N:750-0133-001 DOC.991020-KS516-524-K -20-...
- Page 2 -21-...
- Page 3 TRADEMARKS CISPR A COMPLIANCE: CE NOTICE -23-...
-
Page 4: Table Of Contents
Features ......................... 2 Specifications ....................... 3 Packing List ......................4 Panels ........................4 Mounting the Switches ..................6 Network Switched Ports ..................7 Pin Assignments of MDI-X and MDI RJ-45 ............ 8 UTP Cables ......................9 UTP Connections ....................1 0 Operating Mode .................... - Page 5 1. Introduction...
-
Page 6: Features
1.1 Features... -
Page 7: Specifications
1.2 Specifications... -
Page 8: Packing List
2. Installing the Switch 2.1 Packing List 2.2 Panels... -
Page 10: Mounting The Switches
2.3 Mounting the Switches... -
Page 11: Network Switched Ports
3. Making Network Connections 3.1 Network Switched Ports... - Page 12 3.2 Pin Assignments of MDI-X and MDI RJ-45 PIN# MDI-X Jacks MDI Jack 4,5,7,8...
-
Page 13: Utp Cables
3.3 UTP Cables CONNECTED DEVICE UTP CABLE USED & MAXIMUM LENGTH 10BASE-T device Cat. 3, 4, 5 UTP (100 meters) 100BASE-TX device Cat. 5 UTP (100 meters) -
Page 14: Utp Connections
3.4 UTP Connections -10-... -
Page 15: Operating Mode
3.5 Operating Mode Device Connected Operation Mode Used 10BASE-T hub 10Mbps, half-duplex 100BASE-TX hub 100Mbps, half-duplex Auto-negotiation device Auto-negotiation *2 Non-auto*1 half-duplex device auto-speed-sensing *3, half-duplex Non-auto full-duplex device Not supported *1 Non-auto : non-auto-negotiation *2 determined through auto-negotiation process *3 speed is determined by auto-sensing function -11-... -
Page 16: Port-Based Vlan Support
3.6 Port-based VLAN Support -12-... -
Page 17: Trunking Support
3.7 Trunking Support -13-... - Page 18 -14-...
- Page 19 -15-...
-
Page 20: Led Panels
4. LED Indicators 4.1 LED Panels -16-... -
Page 21: Interpretation
4.2 Interpretation STATE INDICATION POWER No power is supplied to the device. POWER Power is supplied to the device. Link/ACT. An active link is established. Link/ACT. No active link is established. Link/ACT. Blink There are Tx or Rx activities. 10M/100M 100Mbps speed is used.
Need help?
Do you have a question about the KS-516 and is the answer not in the manual?
Questions and answers