Related Manuals for KTI KS-180
Summary of Contents for KTI KS-180
- Page 1 Installation Guide 10/100 Fast Ethernet Switch KS-180 P/N:750-0127-001 DOC.990809-KS180-K -12-...
- Page 2 1999 KTI Networks Inc. All rights reserved. No part of this documen- tation may be reproduced in any form or by any means or used to make any directive work (such as translation or transformation) without per- mission from KTI Network Inc.
- Page 3 The information contained in this document is subject to change without prior notice. Copyright KTI. All Rights Reserved. TRADEMARKS Ethernet is a registered trademark of Xerox Corp. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
-
Page 4: Table Of Contents
Table of Contents Introduction ................. 1 Features ......................... 2 Specifications ....................... 3 Installing the Switch ..............4 Unpacking ......................4 Checking AC Power .................... 4 Installing the Switch .................... 5 Making Network Connections ............ 6 Network Switched Ports ..................6 UTP Cable ...................... -
Page 5: Introduction
1. Introduction Optimized Bandwidth Easy Migration Easy Installation... -
Page 6: Features
1.1 Features... -
Page 7: Specifications
1.2 Specifications Port 1 - 7 Port 8 Cables LED indications Filtering rate Forwarding rate Filtering address RAM buffers Environment Dimension Power... -
Page 8: Installing The Switch
2. Installing the Switch Unpacking Checking AC Power... -
Page 9: Installing The Switch
Installing the Switch... -
Page 10: Making Network Connections
3. Making Network Connections 3.1 Network Switched Ports • Eight 10/100BASE-TX switched ports (Port 1- 8) • Uplink RJ-45 connector for Port 8 PIN# MDI-X Jacks MDI Jack 4,5,7,8... -
Page 11: Utp Cable
3.2 UTP Cable CONNECTED DEVICE UTP CABLE USED & MAXIMUM LENGTH 10BASE-T device Cat. 3, 4, 5 UTP (100 meters) 100BASE-TX device Cat. 5 UTP (100 meters) -
Page 12: Utp Connections
3.3 UTP Connections... -
Page 13: Operating Mode
3.4 Operating Mode Device Connected Operation Mode Used 10BASE-T hub 10Mbps, half-duplex 100BASE-TX hub 100Mbps, half-duplex Auto-negotiation device Auto-negotiation *2 Non-auto*1 half-duplex device auto-speed-sensing *3, half-duplex Non-auto full-duplex device Not supported *1 Non-auto : non-auto-negotiation *2 determined through auto-negotiation process *3 speed is determined by auto-sensing function... -
Page 14: Led Indicators
4. LED Indicators 4.1 LED Panel 4.2 Interpretation POWER LED : Link/Act. LED : COLOR STATE INDICATION No active cable link Green An active link is established. (Half duplex mode). Green Blink Tx or Rx activities (Half duplex mode) Orange An active link is established.
Need help?
Do you have a question about the KS-180 and is the answer not in the manual?
Questions and answers