Table of Contents
Advertisement
Problem
The temperature display shows, "EXXX",
e.g. E300
Appliance operation is not possible,
and -
†
- appear in the temperature display
Appliance operation is not possible,
and -
appear in the temperature display
†˜
The appliance does not heat up, the two
dots flash in the clock display, and
appears in the temperature display, for
example
Electronically controlled functions are mal-
functioning
When an operating mode is switched
on,
or
appears in the temperature
•
œ
display
The appliance has switched off automati-
cally,
flashes in the temperature dis-
‹‹‹
play
Smoke is generated during roasting or grill-
ing
Higher levels of condensation are gener-
ated in the cooking compartment
Enamelled accessories have matt, light-
coloured marks
Door panels are misted up
Replacing the oven light bulb
Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
Place a tea towel in the cold cooking compartment to prevent
1.
damage.
Turn the glass cover anticlockwise and remove it.
2.
Replace the oven light bulb with a bulb of the same type.
3.
Screw on the glass cover again.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)
26
Possible cause
Internal fault in the appliance electronics
The appliance has been locked
D
The appliance controls were automati-
D
cally blocked
A button combination was actuated
‚‡‹©
Energy surges (e.g. lightning strike)
The appliance has not cooled down fully
The appliance has switched off to protect
itself from overheating
Fat is burning on the grill element
Wire rack or universal pan inserted incor-
rectly
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by tempera-
ture differences
Remedial action
Press the
message does not go out, pull out the
mains plug and plug it back in again after
approx. 10 seconds
Deactivate the lock
(see section: Childproof lock)
Deactivate the permanent lock (see
section: Childproof lock)
Switch off the appliance, press and hold
the
±
and hold the
4 seconds, then press and hold the
button again for 3 seconds
Reset the function concerned
Wait until the appliance has cooled down,
then switch on the operating mode again
Turn the operating mode selector back to
the
Û
Continue grilling or roasting until the fat on
the grill element is burnt away
Check the shelf levels (see section: Roast-
ing or grilling)
Open the appliance door briefly from time
to time during operation
Not possible
Heat the appliance up to 100 °C and then
switch off again after 5 minutes
Changing the door seal
If the door seal is defective, it must be replaced. Replacement
seals for your appliance can be obtained from the after-sales
service.
The door seal is attached in four places (figure A). When
replacing it, disconnect and attach the hooks at all four points
(figure B).
Check again to ensure that the seal is seated correctly in the
corners in particular.
clock function button. If the
KJ
info button for 3 seconds, then press
clock function button for
KJ
position
info
±
Advertisement
Table of Contents
