Cleaning The Hook-In Racks; Faults And Repairs - NEFF B15E52.3GB Instruction Manual

Fitting the intermediate panel
Note: During installation, make sure that the lettering "top right"
is upside down at the bottom left.
Insert the intermediate panel towards the back as far as it will
go.
Fitting the door panel
Insert the door panel at an angle towards the back into both
1.
brackets as far as it will go. The smooth surface must face
outwards.
Put the cover back in place and press on it until it clicks in
2.
place.
Refit the appliance door.
3.

Faults and repairs

In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical function is faulty (e.g. indicator
lamps do not light up)
Liquid or runny dough runs to one side
Appliance no longer works,
the clock display
: flashes in the clock display,
‹ ‹‹
"rrr" appears in the temperature display
"E011" appears in the temperature display Permanent assignment of a button
Possible cause
Fuse defective
Appliance not installed level
There was a power cut
‹ : ‹‹ flashes in
The power supply was interrupted while
the appliance was in operation

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.
:
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side (figure A).
Pull the hook-in rack forwards at the rear and unhook to the
2.
side (figure B).
Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the indentation (a) facing
4.
downwards, so that the shelf heights match.
Insert the hook-in rack at the rear as far as it will go and push
5.
to the rear (figure C).
Insert the hook-in rack at the front as far as it will go and push
6.
downwards (figure D).
:
Risk of electric shock!
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see
the Installation instructions)
Reset the time of day (see
section: Electronic clock)
Press the
Reset the time of day (see
section: Electronic clock)
Cancel the permanent assignment of the
button and press the
button
clock function button.
KJ
KJ clock function
25