Volkswagen Jetta Hybrid 2013 Workshop Manual page 89

Caution
Risk of damaging thread in gearbox bracket if bolts are started
at an angle.
♦ Before starting the bolts -arrows-, gearbox bracket -1- and
support arm of gearbox mounting must be perfectly
aligned parallel to each other. If necessary slightly raise
gearbox at rear using a trolley jack or gearbox jack.
♦ Do not remove support bracket -10 - 222 A- until the bolts
securing the assembly mounting have been tightened to
specified torque.
– Pull gearbox upwards using spindle of engine support bracket
until the gearbox bracket makes contact with support arm of
gearbox mounting.
– Check adjustment of assembly mountings ⇒ Rep. gr. 10 ;
Assembly mountings; Checking adjustment of assembly
mountings .
– Remove support bracket -10 - 222 A- from engine.
Install power and control electronics for electric drive -JX1- ⇒
Electrical system, hybrid vehicles; Rep. gr. 93 ; Power and control
electronics for electric drive -JX1- .
– Re-energise high-voltage system and carry out documenta‐
tion ⇒ Electrical system, hybrid vehicles; Rep. gr. 93 ; Re-
energising high-voltage system .
Specified torques
♦ ⇒ "5.1 Assembly overview - assembly mountings", page 78
7-speed dual clutch gearbox 0CG - Edition 08.2012
Jetta Hybrid 2013 ➤
5. Assembly mountings
85