Jetta Hybrid 2013 ➤
7-speed dual clutch gearbox 0CG - Edition 08.2012
– Loosen bolts -1- for gearbox bracket by approx. one turn and
unscrew bolts -2-.
– Then lower engine and gearbox slightly using the spindles of
engine support bracket -10 - 222 A- .
•
At most, 4 turns are sufficient to remove the gearbox console.
•
Do not lower further. For lowering the assembly further the
pendulum support has to be removed first.
– Unscrew bolts -arrows A- and -arrows B-. Remove gearbox
bracket -1-.
Note
An earth strap is attached to the centre hex stud -arrows B-
.
Installing gearbox bracket
Install in reverse order of removal, observing the following:
Note
Always renew bolts that are tightened with specified tightening
angle.
84
Rep. gr.34 - Controls, housing