Connecting The Headset; Connecting The Usb Data Cable - Gigaset SL450 User Manual

Handset
Setting the date and time
Set the date/time so that the correct date and time can be assigned to incoming calls, and to
enable the alarm to be used.
¤
Press the display key Time
or, if the date and time have already been set:
¤
. . . use
OK
The active cursor position flashes
. . . switch between cursor positions with
Enter date:
¤
. . . using enter the day, month and year in 8-digit format,
e. g.
Enter time:
¤
. . . using enter hours and minutes in 4-digit format,
e. g.
Save settings:
¤
Press the display key Save. . . . Saved is shown in the display and
a confirmation tone sounds.
Return to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.

Connecting the headset

¤
Connect the headset with 2.5 mm jack to the left side of the
handset .
1
For information on recommended headsets, see the relevant product
page at www.gigaset.com/sl450.
The headset volume corresponds with the setting for the receiver
volume ( p. 60).

Connecting the USB data cable

For data exchange between the handset and PC:
¤
Connect the USB data cable with micro-USB plug into the
USB socket at the bottom of the handset
Connect the handset directly to the PC, not via a
USB hub.
10
to select Settings
. . . change cursor position with
for 07:15.
OK Date/Time
for 15/08/2015.
.
1
Calls Time
Date/Time
Date:
15/08/2015
Time:
00:00
Back
1
1
Save