Mount Into The Dashboard - Philips cem5100 User Manual

RE AR AUX
R L
L
R
REAR FRONT
i h
Connector
1 ANTENNA
2 FRONT LINE OUT
R (Socket)
3 FRONT LINE OUT L
(Socket)
4 REAR LINE OUT R
(Socket)
5 REAR LINE OUT L
(Socket)
6 OE REMOTE
(Purple)
7 SUBWOOFER (Blue) Subwoofer
8 REAR AUX LINE
OUT R
9 REAR AUX LINE
OUT L
Tip
•
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the unit.

Mount into the dashboard

1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
g
f
Connect to
Antenna
Front right
speaker
Front left
speaker
Rear right
speaker
Rear left
speaker
OE Remote
Rear Aux
right
Rear Aux left
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2
Ensure that car dashboard opening is
within these measurements:
3
Remove the mounting sleeve with the
supplied disassembly tools.
4
Install the sleeve into the dashboard and
bend the tabs outward to fix the sleeve.
Note
•
If the unit is not fixed by sleeve but by the supplied
screws, skip this step.
EN
11