Assembly And Operating - Cub Cadet CCH410 Instruction Manual

INSTALLING THE DRIVE UNIT ON
THE HEDGE TRIMMER ATTACHMENT
NOTE:
The Power Lok™ Drive
Unit must be installed on the
Hedge Trimmer Attachment. If the
unit you purchased does NOT
include the drive unit, one must be
purchased separately. Refer to the
Accessories section.
WARNING:
Cell from the drive unit before
installing the drive unit on the hedge
trimmer attachment.
1. Pull the locking lever (1) outward from
the locking collar (2). Align the groove
(3) in the locking collar with the
matching key (4) on the end of the
hedge trimmer attachment shaft (5)
(Fig. 1).
2. Insert the hedge trimmer attachment
shaft into the locking collar until the
installation mark (6) meets the
locking collar.
NOTE: Make sure the hedge trimmer
attachment shaft is fully inserted into
the locking collar. If it is not fully
inserted, the electrical connection will
not be made and the hedge trimmer
attachment will not function properly.
3. When the hedge trimmer attachment
shaft is fully inserted into the locking
collar, push the locking lever back
toward the locking collar to lock the
assembly together (Fig 2).
NOTE: Make sure the locking lever is
fully pressed toward the locking collar.
This is important to ensure the
assembly is properly locked together.

ASSEMBLY AND OPERATING

Remove the Power
4
6
13
2
3
5
Fig. 1
Fig. 2
1