Specifications; Important Safety Instructions - Makita AN620H Instruction Manual

ENGLISH
(Original instructions)
1 Compressor air output per
minute
2 Nailing frequency (times/min.)
3 Adjuster
4 Shallow
5 Deep
6 Too deep
7 Flush
8 Too shallow
9 Hook
10 Hole
11 Protrusion
12 Nose adapter
13 Lever
14 Door

SPECIFICATIONS

Model
Air pressure
Nail length
Nail capacity
Min. hose diameter
Dimensions (L x H x W)
Net weight
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2" x 4" housing.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
WHEN USING THIS
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED
TO REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and mainte-
nance of the tool, read this instruction manual before
using the tool.
• Always wear safety glasses to protect your eyes from
dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
Explanation of general view
15 Adjustfit
16 Change plate
17 Arrow
18 Nail guide
19 Feeder
20 Trigger
21 Contact element
22 Change lever
23 0.7 mm or less thick for steel
plate
24 Thickness of workpiece
25 10 mm or more
26 C-shaped steel
(Thickness 1.6 mm – 2.3 mm)
27 Nail driven to a proper depth
ENB109-2
TOOL, BASIC SAFETY
28 Nail driven too deep will cause
29 Nail length
30 Wood thickness
31 Concrete range 10 – 15 mm
32 Exhaust cover
33 Small rod
34 Screwdriver
35 Cap
36 Drain cock
37 Air filter
38 Oiler
39 Pneumatic oil
AN620H
0.98 – 2.26 MPa (9.8 – 22.6 bar)
Wire-collated coil nail 45 mm – 65 mm
Sheet-collated coil nail 38 mm – 65 mm
Wire-collated coil nail 250 pcs, 300 pcs
Sheet-collated coil nail 200 pcs
5.0 mm
282 mm x 277 mm x 136 mm
1.8 kg
• For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or nail injury. The safety glasses
and the face shield should conform with the require-
ments of AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
Safety glasses
Face shield
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or rolled
up. No necktie should be worn.
• Rushing the job or forcing the tool is dangerous. Han-
dle the tool carefully. Do not operate when under the
influence of alcohol, drugs or the like.
deformation of workpieces
7