Makita AN611 Instruction Manual
  1. Manuals
  2. Brands
  3. Makita Manuals
  4. Nail Gun
  5. AN611
  6. Instruction manual
Makita AN611 Instruction Manual

Makita AN611 Instruction Manual

Construction coil nailer
Hide thumbs Also See for AN611:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual
Construction Coil
Nailer
MODEL AN611
005235
I N S T R U C T I O N
M A N U A L
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Advertisement

Table of Contents
loading

Related Manuals for Makita AN611

Summary of Contents for Makita AN611

  • Page 1 Construction Coil Nailer MODEL AN611 005235 I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

  • Page 2: Specifications

    SPECIFICATIONS Model AN611 Air pressure 0.44 - 0.83 Mpa (4.4-8.3 bar) Wire welded nails 32 mm - 65 mm Applicable length Plastic sheet collated nails 32 mm - 50 mm Nail capacity 200 - 400 pcs. Dimensions (L X H X W) 332 mm X 317 mm X 127 mm Min.

  • Page 3: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS ENB087-1 WARNING: WHEN USING THIS TOOL, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF PERSONAL INJURY, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS. • For personal safety and proper operation and Do not operate the tool with any power maintenance of the tool, read this instruction source other than that specified in the tool manual before using the tool.
  • Page 4 On rooftops and other high locations, nail as • you move forward. It is easy to lose your footing Ask Makita’s Authorized service centers for peri- if you nail while inching backward. When nailing odical inspection of the tool. against perpendicular surface, nail from the top •...

  • Page 5: Installation

    INSTALLATION Selecting compressor 005236 • Select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing (L/min) frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 50 times per minute at a compression of 0.59 Mpa (5.9 bar), a compressor with an air output over 80 liters/ minute is required.

  • Page 6: Functional Description

    • When an air set is not used, oil the tool with pneumatic tool oil by placing 005237 2 (two) or 3 (three) drops into the air fitting. This should be done before and after use. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced.
  • Page 7 • Lift and turn the coil support plate to set it to the correct step. When 005242 loading 57 or 65 mm long nails, use the bottom step. When loading 45 or 50 mm long nails, use the middle step. When loading 32 or 38 mm long nails, use the top step.

  • Page 8: Operation

    OPERATION CAUTION: • Make sure all safety systems are in working order before operation. To drive a nail, you may place the contact element against the workpiece and pull the trigger, or Pull the trigger first and then place the contact element against the work- piece.
  • Page 9 Memo...
  • Page 10 Memo...
  • Page 11 Memo...
  • Page 12 Makita Corporation 884178C5...

Table of Contents