Security Function Notice - Sanyo PLC-XF1000 Service Manual

Security Function Notice

This projector provides security functions such as "Key lock", "PIN code lock" and "Logo PIN code lock". When the
projector has set these security function on, you are required to enter correct PIN code to use the projector. If you
do not know the correct PIN code to the projector, the projector can no longer be operated or started. In this case,
you must reset those function first according to the resetting procedure described below and then check up on the
projector.
Function
Key lock
PIN code lock
Logo PIN code lock
Resetting procedure
1
Turn off the projector with the Mains switch.
2
As pressing the SeLect button on the projector, turn on the projector with the Mains switch. Keep pressing
the SeLect button until the READY indicator lights continuously.
This is complete the resetting of the security function. The PIN code lock and Logo PIN code lock are reset
as the initial PIN code at the factory and the Key lock function is disabled.
Please refer to the owner's manual for further information of the security functions.
description
Locks operation of the side control or the remote con-
trol.
If the Key lock is enabled with side control lock, the
projector can no longer be started.
Initial setting: Key lock function is disabled
Prevents the projector from being operated by an un-
authorized person.
Initial code: "1234"
Prevents an unauthorized person for changing the
start-up logo on the screen.
Initial code: "4321"
-17-