Security Function Notice; Anititheft Alarm Function Disable - Sanyo PLC-XL40 Service Manual

Security Function Notice

This projector provides security functions such as "Key lock", "PIN code lock" and "Logo PIN code lock". When the pro-
jector has set these security function on, you are required to enter correct PIN code to use the projector. If you do not
know the correct PIN code to the projector, the projector can no longer be operated or started. In this case, you must
reset those function first according to the resetting procedure described below and then check up on the projector.
Function
Key lock
PIN code lock
Logo PIN code lock
Resetting procedure
1
Disconnect the AC power cord from the AC outlet.
2
As pressing the SELECt button on the projector, connect the AC power cord into an AC outlet again. Keep
pressing the SELECt button until the POWER indicator lights continuously.
This is complete the resetting of the security function. The PIN code lock and Logo PIN code lock are reset as
the initial PIN code at the factory and the Key lock function is disabled.
Please refer to the owner's manual for further information of the security functions.

Anititheft Alarm Function Disable

This projector provides an Antitheft alarm function which
works when detecting a vibration to protect the projector
from a suspicious person.
Release the alarm setting
Press the F button and input the four-digit PIN code
within 10 seconds. (default PIN code "1111") When the
alarm is released, you will hear high-pitched confirma-
tion sound.
When inputting an incorrect PIN code, you will hear low-
pitched sound. If you input incorrect PIN codes 3 times,
the alarm will start ringing.
If you forget the PIN code to release the alarm setting,
press and hold the button 3 and F button at the same
time for more than 3 seconds.
description
Locks operation of the top control or the remote con-
trol.
If the Key lock is enabled with top control lock, the pro-
jector can no longer be started.
Initial setting: Key lock function is disabled
Prevents the projector from being operated by an un-
authorized person.
Initial code: "1234"
Prevents an unauthorized person for changing the
start-up logo on the screen.
Initial code: "4321"
Side Control
-7-
F button button 1, 2, 3