Page 1
User / Installation Manual D-Class Marine Amplifier MS-DA51600 Specifications and design are subject to change without notice...
Page 2
GROUND CONNECTION When wiring the FUSION amplifier ensure that the cable When grounding/earthing your amplifier ensure that the is protected from sharp objects and always use rubber location is a good source of ground.
LEVEL CONTROL This control is used to match the input level of the amplifier to the output level of you head unit. We recommend the following method. NOTE: Remove screws and the top cover of amplifier to access controls. Turn the amplifier level to zero Adjust the level control until the desired maximum volume is achieved without distortion.
This displays “green” if the amplifier has been correctly powered up and ‘red’ if any faults are present. 7. FUSES: Please ensure the correct type of fuse is fitted. For MS-DA51600 2 x the frequency signal from 10Hz - 80Hz. This signal often contains no 40A fuses.
Page 8
TECH TIPS BASIC TOOLS In any installation these basic tools may be required. For custom type installations, additional tools may be neccesary. OHMS LAW SIMPLIFIED...
Page 9
SERIES AND PARALLEL SUBWOOFER WIRING FOR DUAL VOICE COIL SUBWOOFERS PARALLEL VOICE COIL WIRING (2 OHM OPERATION) To wire a 4 Ohm DVC subwoofer in parallel to get 2 Ohm, use two short pieces of speaker wire and link the positive from one coil to the positive of the second coil, and do the same for the negative as shown below.
Page 10
PARALLEL WIRING FORMULA FOR 2 SPEAKERS 4 Ohm 8 Ohm 2.67 Ohms R1 x R2 4 Ohms x 8 Ohms = LOAD IMPEDANCE = 2.67 Ohms R1 + R2 4 Ohms + 8 Ohms SERIES WIRING FORMULA FOR 2 SPEAKERS 4 Ohm 4 Ohm 8 Ohms...