GROUND CONNECTION When wiring the FUSION amplifier ensure that the cable When grounding/earthing your amplifier ensure that the is protected from sharp objects and always use rubber location is a good source of ground.
LEVEL CONTROL This control is used to match the input level of the amplifier to the output level of you head unit. We recommend the following method. NOTE: Remove screws and the top cover of amplifier to access controls. Turn the amplifier level to zero Adjust the level control until the desired maximum volume is achieved without distortion.
14. FUSION LOW FREQUENCY CONTROL: 20. FRONT FILTER FREQUENCY: The FUSION Low Frequency Control (F.L.F.C.) is a dual stage control interface. The combination of a Subsonic filter & a Bass Boost control This sets the crossover frequency point for the front filter between 32Hz and 320Hz.
TECH TIPS BASIC TOOLS In any installation these basic tools may be required. For custom type installations, additional tools may be neccesary. • Electric drill • Flat blade screwdriver • Crimping tool • Electrical tape • Allen key set • Phillips screwdriver • Wire strippers • Silicon sealant • Utility knife, sabre saw, jigsaw, nibbler OHMS LAW SIMPLIFIED...
Page 9
SERIES AND PARALLEL SUBWOOFER WIRING FOR DUAL VOICE COIL SUBWOOFERS PARALLEL VOICE COIL WIRING (2 OHM OPERATION) To wire a 4 Ohm DVC subwoofer in parallel to get 2 Ohm, use two short pieces of speaker wire and link the positive from one coil to the positive of the second coil, and do the same for the negative as shown below.
Page 10
PARALLEL WIRING FORMULA FOR 2 SPEAKERS 4 Ohm 8 Ohm 2.67 Ohms R1 x R2 4 Ohms x 8 Ohms = LOAD IMPEDANCE = 2.67 Ohms R1 + R2 4 Ohms + 8 Ohms SERIES WIRING FORMULA FOR 2 SPEAKERS 4 Ohm 4 Ohm 8 Ohms...