LG LDG3015SB Service Manual page 46

WARNING
• Turn off the electrical supply and
gas supply going to the range.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
gas range handling the sheet metal
part.
- Sharp edge may be present and you can cut
yourself.
3) UPPER OVEN BROIL BURNER
a) Remove oven door and Broil burner
assembly. Then remove the wire cover
using a phillips head screwdriver (See the
page 3-11).
b) Release the connector of the lgniter.
c) Remove the orifice spud from nozzle holder
using a 13/32" or 10mm wrench.
d) Install the LP orifce spud(F) to the nozzle
holder. To prevent leakage, make sure the
orifice spud is securely screwed into the
nozzle holder.
CONVERSION TO LP GAS
Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise
Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise
Counterclockwise Counterclockwise
Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise
to remove to remove to remove
to remove to remove to remove to remove
to remove to remove to remove to remove
to remove to remove to remove to remove
to remove to remove to remove
Clockwise to install Clockwise to install Clockwise to install
Clockwise to install Clockwise to install Clockwise to install Clockwise to install
Clockwise to install Clockwise to install Clockwise to install Clockwise to install Clockwise to install Clockwise to install
Clockwise to install Clockwise to install Clockwise to install Clockwise to install Clockwise to install
6. Turn on the Electrical and Gas Supply to
continue with flame adjustment.
7. ADJUSTING THE AIR SHUTTER
For bake burner, adjust the Air Shutter for LP
gas, loosen the Philips head screw and rotate the
shutter to the fully open position as shown Fig.1.
NOTE: When converting the unit back to natural
gas the bake burners air shutter should be also in
fully open position.
For broil burner, adjust the Air Shutter for LP gas,
loosen the Philips head screw and rotate the air
shutter to the fully open position as shown Fig.1
(Refer to Fig.1)
NOTE: When converting the unit back to natural
gas the broil buners air shutter should be in
0.4inch (10mm) open position. (Refer to Fig.2)
Screw
Air Shutter
Fig.1
Check the flame size. The flame should have
approximately 1-inch blue cones.
After 30 seconds of the
burner operation, check
for flame stability.
If the flame is lifting off of
the burner ports gradually
reduce the air shutter
opening until flames have
stabilized. Some yellow tipping may be normal
when used on LP.
5-4
Counterclockwise
to 0.4inch(10mm)
open position.
Screw
Air Shutter
Fig.2
Approx. 1"