Conversion To Lp Gas - LG LDG3015SB Service Manual

WARNING
• Turn off the electrical supply and
gas supply going to the range.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
gas range handling the sheet metal
part.
- Sharp edge may be present and you can cut
yourself.
Tools required
• Adjustable wrench
• 13/32" or 10mm open-end wrench
5/16" or 8mm open-end wrench
• Phillips head screwdriver
• Flat bladed screwdriver(blade width approximately
3/32" across)
• Nut drivers : 13/32" or 10mm
5/16" or 8mm
1. PREPARE RANGE FOR CONVERSION
1) Turn off gas supply to the range.
2) Turn off the electrical power to the range.
CAUTION
• If the gas supply to the range is
disconnected for any reason see
the installation instructions for
proper connection and safety
precautions.

CONVERSION TO LP GAS

2. CONVERT THE PRESSURE REGULATOR
• Do not remove the pressure
regulator from the range.
The pressure regulator is located at the rear of
the range.
3. CONVERTING YOUR REGULATOR
1) Unscrew the hex-nut cap by using an
adjustable wrench.
2) Separate plastic cap and hex-nut cap by
turning the plastic cap to 180°.
3) Assemble plastic cap in the opposite side.
4) Screw the hex-nut cap back into the regulator.
Do not over tighten.
LPG
5-1
WARNING
Pressure regulator
Natural