LG LDG3015SB Service Manual page 45

WARNING
• Turn off the electrical supply and
gas supply going to the range.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
gas range handling the sheet metal
part.
- Sharp edge may be present and you can cut
yourself.
4) To prevent leakage, make sure the orifice
spuds are securely screwed into the gas
supply tubes.
5) For the right front burner of LDG3015S, the
choke and self threading screw will be needed
as shown Fig Insert the choke into the burner
base, then insert the set screw into the burner
base and tighten securely. Make sure the
screw head is against the shoulder (within
choke notch), so it does not have any
rotational movement.
<Fig>
6) Put the old orifice spuds into conversion kits
and place back on the range for possible
future conversion.
NOTE: If an orifice spud is accidentally
dropped, the cooktop plate can be
raised (see the page 3-4)
CONVERSION TO LP GAS
Self threading
screw
Choke
17k burner base
5. CONVERT THE OVEN BURNER ORIFICES
1) UPPER OVEN BAKE BURNER
a) Remove oven door, oven bottom, frame
guide, nozzle case and oven burner
assembly (See the page 3-12).
b) Remove the orifice spud from nozzle holder
using a 13/32" or 10mm wrench.
c) Install the LP orifce spud(F) to the nozzle
holder. To prevent leakage, make sure the
orifice spud is securely screwed into the
nozzle holder.
Clockwise to install
Clockwise to install Clockwise to install Clockwise to install Clockwise to install Clockwise to install Clockwise to install
Clockwise to install Clockwise to install Clockwise to install Clockwise to install
Clockwise to install Clockwise to install Clockwise to install Clockwise to install
Clockwise to install Clockwise to install Clockwise to install
2) LOWER OVEN BAKE BURNER
a) Remove oven door, oven bottom, frame
guide, nozzle case and oven burner
assembly (See the page 3-13).
b) Remove the orifice spud from nozzle holder
using a 13/32" or 10mm wrench.
c) Install the LP orifce spud(H) to the nozzle
holder. To prevent leakage, make sure the
orifice spud is securely screwed into the
nozzle holder.
5-3
Counterclockwise Counterclockwise Counterclockwise
Counterclockwise Counterclockwise Counterclockwise Counterclockwise
Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise
Counterclockwise Counterclockwise Counterclockwise Counterclockwise Counterclockwise
to remove to remove to remove to remove to remove
to remove to remove to remove to remove to remove to remove
to remove to remove to remove to remove
to remove to remove to remove