Makita BTD129 Technical Information page 11

W
iring diagram
Fig. D-4
Be careful not to put Lead wires
on Ribs A, B and D.
Route Lead wires of Circuit
board and those of Stator
between Rib A and Boss.
Fix Lead wires of Stator and
those of Circuit board in the
bottom of either Lead wire
holders.
Put one or more Lead wires
of Stator into both Lead wire
holders.
While routing Lead wires connecting to
Terminal over the projection of Controller,
assemble Controller and Terminal to
Housing (L).
projection
of Controller
Terminal
Wiring in Housing (L)
Rib B
Rib D
Rib A
Boss
Projection
of Controller
Housing (L)
Housing (R) side
Put the slack portion of Lead wires
Printed wiring
of Stator and those of Printed wiring
board
board in this place.
Stator
Switch
Controller
Terminal
Controller
P 11/ 12
Be careful not to put
Lead wires on this Boss.
Be careful not to put
Lead wires on these Ribs.
Connecting terminal
Be careful not to put
Connecting terminals
under or on Capacitor.
Capacitor