Callback Security Commands - Multitech MT2834BLR User Manual

DEFAULT: n/a
DESCRIPTION: Causes modem to wait for ringback, then 5 seconds of
silence before processing next part of command.
COMMAND: +++AT<CR>
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: In-band Escape Sequence. Places modem in Command
mode while still remaining On-Line. Enter +++ followed by
the letters A and T, up to ten command characters, and a
RETURN.
COMMAND: BREAK AT<CR>
VALUES: n/a
DEFAULT: n/a
DESCRIPTION: Out-of-band Escape Sequence. Places modem in
Command mode while still remaining On- Line. Not
preceded by AT. Enter a BREAK signal, followed by the
letters A and T, up to sixty command characters, and hit
RETURN.
COMMAND: *C <Enter>
VALUES: 0, 1, 2
DEFAULT: 0
DESCRIPTION: Caller ID Reporting the Call Traffic Window displays the
phone number and name of the caller (if the caller's phone
line supports Caller ID). The call must be answered after
the second ring to receive the information. This feature
requires a modem hardware upgrade, Caller Id-enabled
phone lines, and firmware version greater than 8.07a or
2.07a. The firmware is disabled by default, enabled by the
*C command.

4.1.1 Callback Security Commands

COMMAND: #DBn
VALUES: n= 0, 1, or 2
DEFAULT: DB0
DESCRIPTION: #DB0 disables Callback Security and answering Yes to the
prompt turns off Callback Security and erases stored phone
numbers and passwords. Answering No to the prompt
aborts the command.
#DB1 activates remote and local password security.
#DB2 activates remote password security.
COMMAND: #CBNyyxxxxxx
VALUES: n/a
Chapter 4 - Commands
43