Completion Of Operations - Minelab F3 Mine Detector Operation Manual

2 metres
Figure 29: Operating Detectors in Close Proximity

6.8 Completion of Operations.

At the completion of operations, the F3 should be checked with the
Test Piece before switching off to ensure satisfactory performance
before being packed away. Once completed:
a. Turn the detector off.
b. Clean the detector and inspect for any signs of damage (Chapter
7).
c. Remove the batteries from the Battery Pack and stow in the Hard
Case or Soft Carry Bag.
d. Disconnect the Earset.
e. Retract the Middle and Lower Shafts rotating the Coil to the
stowed position.
f. Stow the detector in the Hard Case or Soft Carry Bag.
g. Check all components are accounted for (especially the Test
Piece and Earset) and are correctly packed.
NOISE CANCEL
42