Din Rear-Mount; Removing The Unit; Fastening The Front Panel - Pioneer DEH-4200SD Operation Manual

Installation
3. Install the unit as illustrated.
Screw
Screw (M4 x 8)
• Make sure that the unit is installed securely in place. An unstable installation may
cause skipping or other malfunctions.

DIN Rear-mount

1. Determine the appropriate position where the holes on the bracket and the side
of the unit match.
2. Tighten two screws on each side.
Tapping screw
(5 mm x 8 mm)
Mounting bracket
Nut
Firewall or metal support
Metal strap
Dashboard or console
Autogood products internet store http://130.com.ua

Removing the unit

1. Extend top and bottom of the trim ring outwards to remove the trim ring. (When
reattaching the trim ring, point the side with the groove down.)
Trim ring
• Releasing the front panel allows easier access to the trim ring.
2. Insert the supplied extraction keys into both sides of the unit until they click into
place.
3. Pull the unit out of the dashboard.

Fastening the front panel

If you do not plan to detach the front panel, the front panel can be fastened with
supplied screw.
Screw
3