Technical Specifications - VINCENT SA-T7 Instructions For Use Manual

Symptom
Poor sound quality
The remote control
cannot perform any
functions
Humming low fre-
quency noise is audi-
ble, even as no
audio source is play-
ing back
Frequency response:
Nominal Output Voltage:
Total Harmonic Distortion:
Amplifying:
Input sensitivity:
Signal to Noise Ratio:
Intermodulation ratio (DIN IEC268):
Input Impedance:
AC power connection type:
Inputs:
Outputs:
Dimensions (W x H x D):
Weight:
Colour:
Tubes:
Vincent
38
SEARCH FOR ERRORS
Possible Cause
The cable connections are not tight, the con-
nectors are dirty or a cable is defective.
A record player has been connected to a line
level input without using a phono preamplifier.
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
See section "Net frequency noise" in the
chapter "Tips".

TECHNICAL SPECIFICATIONS

Countermeasure
Check the cables and cable connections.
Interconnect a phono preamplifier.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear, wit-
hin a 7-metre distance and, if possible, facing
the unit.
Switch on the unit.
See section "Net frequency noise" in the
chapter "Tips".
20 Hz - 20 kHz ± 0.1 dB
3 V
< 0.001 % (1 kHz, output voltage
2 Veff on 100 kΩ)
typ 13.3 dB (Volume control max. Gain)
430 mV (for 2 V output voltage)
> 90 dB
>100 dB (60 Hz / 7 kHz, 4:1)
22 kΩ
230 V/50 Hz
6 x analog RCA stereo (LINE IN)
1 x digital optical
1 x digital coaxial
2 x RCA stereo (PRE OUT),
1 x RCA stereo (REC OUT)
430 x 135 x 370 mm
8.5 kg
silver / black
4 x CV6189; 4 x 6S3P-EV; 1 x 85A2