Connect To The Power Source
The display should be installed close to an easily accessible power outlet�
Fully insert the prongs into the power outlet socket� A loose connection may
cause image degradation�
If there is power to the display, the front LED at the bottom of the display will
be either none or red� A red LED means the display is in standby mode�
Power On/Off Your New LCD Display
Press the power button on the remote control or press the power button
located on the side of the display� The display will power on�
Power Mode Status
Mode
LED Status
When in on mode, the Display operates as follows if no external signal is
input�
1�
When the external device is connected to the VGA terminal, the NO
SIGNAL menu is displayed and 15 seconds later the Display switches to
Power button
On
None
English-15
or
Standby
Red
Warming up
Blinking Red