Connecting Your Headphones - Bowers & Wilkins P7 Owner's Manual

3. Connecting your headphones

Your P7 Headphones can be connected to any
audio device with a 3.5mm jack headphone output.
The remote and mic cable fitted to P7 Headphones
incorporates an iPhone , iPod and iPad
® ®
microphone and audio control. Its use is described
in the following section of this manual.
If using your P7 Headphones with anything other
than an Apple ® device the remote and mic cable
functionality may vary. If perfomance is affected
the supplied universal cable can be substituted.
Detaching the remote and mic cable and fitting the
universal cable is described below and illustrated in
diagram 3.
• Unfold the headphones and remove the left
earpad by gently pulling it away from the body of
the earpiece. Removing the left earpad reveals the
cable connection plug and socket.
• Gently grasp the cable just below the earpiece
and lift upwards. The connection plug and socket
will raise up.
• Now gently grasp the connection plug and pull it
out of the socket.
• With the remote and mic cable now disconnected,
take the universal cable and identify the 2.5mm
connection plug.
• Insert the 2.5mm (angled) connection plug into
the left earpiece socket and press the connection
plug moulding into its routing channel.
• Replace the left earpad. Make sure that the
earpad location pins and sockets engage
accurately.
4. Using your P7 Headphones with
iPhone, iPad and iPod
Your P7 Headphones incorporate a combined
microphone and audio control, integrated within the
remote and mic cable, that enables you to make
or answer calls while wearing the headphones.The
control also enables you to play, pause and skip
songs. The microphone and control is illustrated in
diagram 4
The control incorporates three click switches, one in
the middle and one at either end, and operates as
follows:
• Click the end switch engraved "+" to increase
phone or song volume.
• Click the end switch engraved "–" to decrease
phone or song volume.
• Click the middle switch once to answer a call.
• Click the middle switch once to end a call.
• Click the middle switch once to play or pause a song
• Click the middle switch twice to skip to the next
song.
• Click the middle switch three times to skip to the
previous song.
compatible
®
Diagram 3
Changing the cable
Diagram 4
The microphone and audio controls
1x
1x
2x
3x
4