Connecting Your Headphones - Bowers & Wilkins P9 Manual

3. Connecting your headphones

Your P9 Signature Headphones can be connected
to any audio device with a 3.5mm jack headphone
output. The remote and mic cable fitted to P9
Signature Headphones incorporates an iPhone
iPod and iPad compatible microphone and audio
® ®
control. Its use is described in the following section
of this manual.
If using your P9 Signature Headphones with anything
other than an Apple device the remote and mic cable
®
functionality may vary. If performance is affected the
supplied universal cable or 5 metre cable can be
substituted. Detaching the remote and mic cable
and fitting the alternate cables is described below
and illustrated in diagram 3.
• Unfold the headphones and remove the left earpad
by gently pulling it away from the body of the
earpiece. Removing the left earpad reveals the
cable connection plug and socket.
• Gently grasp the cable just below the earpiece and
lift upwards. The connection plug and socket will
raise up.
• Now gently grasp the connection plug and pull it
out of the socket.
• With the remote and mic cable now disconnected,
take the alternate cable and identify the 2.5mm
connection plug.
• Insert the 2.5mm (angled) connection plug into the
left earpiece socket and press the connection plug
moulding into its routing channel.
• Replace the left earpad. Make sure that the earpad
location pins and sockets engage accurately.
4. Using your P9 Signature Headphones
with iPhone, iPad and iPod
Your P9 Signature Headphones incorporate a
combined microphone and audio control, integrated
within the remote and mic cable, that enables you to
make or answer calls while wearing the headphones.
The control also enables you to play, pause and skip
songs. The microphone and control is illustrated
in diagram 4
The control incorporates three click switches, one
in the middle and one at either end, and operates
as follows:
• Click the end switch engraved "+" to increase
phone or song volume.
• Click the end switch engraved "–" to decrease
phone or song volume.
• Click the middle switch once to answer a call.
• Click the middle switch once to end a call.
• Click the middle switch once to play or pause a song
• Click the middle switch twice to skip to the next song.
• Click the middle switch three times to skip to the
previous song.
,
®
Diagram 3
Changing the cable
Diagram 4
The microphone and audio controls
1x
1x
2x
3x
4