Advertisement
3. Connecting your headphones
Your P5 Series 2 Headphones can be connected
to any audio device with a 3.5mm jack headphone
output. The remote and mic cable fitted to P5 Series
2 Headphones incorporates an iPhone
iPad
compatible microphone and audio control.
®
Its use is described in the following section of this
manual.
If using your P5 Series 2 Headphones with anything
other than an Apple
device the remote and
®
mic cable functionality may vary. If perfomance
is affected the supplied universal cable can be
substituted. Detaching the remote and mic cable
and fitting the universal cable is described below and
illustrated in diagram 3.
• Unfold the headphones and remove the left
earpad by gently pulling it away from the body of
the earpiece. Removing the left earpad reveals the
cable connection plug and socket.
• Gently grasp the cable just below the earpiece
and lift upwards. The connection plug and socket
will raise up.
• Now gently grasp the connection plug and pull it
out of the socket.
• With the remote and mic cable now disconnected,
take the universal cable and identify the 2.5mm
connection plug.
• Insert the 2.5mm (angled) connection plug into
the left earpiece socket and press the connection
plug moulding into its routing channel.
• Replace the left earpad. Make sure that the
earpad location pins and sockets engage
accurately.
4. Using your P5 Series 2 Headphones
with iPhone, iPad and iPod
Your P5 Series 2 Headphones incorporate a
combined microphone and audio control, integrated
within the remote and mic cable, that enables you to
make or answer calls while wearing the headphones.
The control also enables you to play, pause and skip
songs. The microphone and control is illustrated in
diagram 4
The control incorporates three click switches, one in
the middle and one at either end, and operates as
follows:
• Click the end switch engraved "+" to increase
phone or song volume.
• Click the end switch engraved "–" to decrease
phone or song volume.
• Click the middle switch once to answer a call.
• Click the middle switch once to end a call.
• Click the middle switch once to play or pause a song
• Click the middle switch twice to skip to the next
song.
• Click the middle switch three times to skip to the
previous song.
, iPod
and
®
®
Diagram 3
Changing the cable
Diagram 4
The microphone and audio controls
1x
1x
2x
3x
4
Advertisement
