Installation Of Battery; Connections; Remote Control Operation Range; Handling The Remote Control - VIETA VH-MS470BT User Manual

Installation of Battery

1. Remove the insulating mylar strip from the battery. It
is located at the bottom back side of the remote control.
2. Loosen the screw on the battery compartment
cover with a screwdriver. Pull out the battery
compartment with your fingernails.

3. Replace a new battery (size 2025) correctly and fully
insert the battery compartment back to the original
position. Tighten the screw with a screwdriver.

Handling the Remote Control

• Remove the batteries if the remote control is not going
to be used for an extended period of time.
• To avoid possible failure, read the following
instructions and handle the remote control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under the direct
sunlight or near sources of excessive heat.
• Do not use caustic cleaners ( porcelain, stainless
steel, toilet, or oven cleaner etc. ) on the remote, as it
may suffer damage.
Note:
Remove the battery from remote control handset when it
is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.
28


Remote Control Operation Range

30° 30°
Max. 5 m
AUX
DISPLAY
Point the remote control to the unit no more than 5
meters from the remote control sensor and within
60° horizontally and 40° vertically of the front of the unit.
The operating distance may vary according
to the brightness of the room.
Note:
• Make sure that there is no obstacle between the
infrared remote sensor of the unit and remote
control. If you install the unit on rack, etc.., the remote
controllable range may decrease
depending on the thickness or colour of glass door of
rack.
• Do not expose the infrared remote sensor to direct
sunlight or other strong light, such as inverter
fluorescent light.

Connections

Caution: Make all connections before plugging the
unit into the AC Power outlet. Connecting the FM
Antenna.
Connect the supplied FM Antenna to the FM Antenna
socket on the rear of the unit.
Caution:
To avoid noise, keep Antenna away from the unit, the
connecting cable and the AC power cable.
CABLE
AUX IN 1 AUX IN 2
ANTENNA
L L
FM
R R
ANTENNA
FM
CD Microsystem