Installation Of Battery; Remote Control Operation Range; Handling The Remote Control - VIETA VH-MS570BT User Manual

Installation of Battery

1. Remove the insulating mylar strip from the battery.
It is located at the bottom back side of the remote
control.
2. Loosen the screw on the battery compartment
cover with a screwdriver. Pull out the battery
compartment with your fingernails.

3. Replace a new battery (size 2025) correctly and fully
insert the battery compartment back to the original
position. Tighten the screw with a screwdriver.

Handling the Remote Control

• Remove the batteries if the remote control is not going
to be used for an extended period of time.
• To avoid possible failure, read the following
instructions and handle the remote control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
28

• Do not place the remote control under the direct
sunlight or near sources of excessive heat.
• Do not use caustic cleaners ( porcelain, stainless
steel, toilet, or oven cleaner etc. ) on the
remote, as it may suffer damage.
Note:
Remove the battery from remote control handset when it
is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.

Remote Control Operation Range

Point the remote control to the unit no more than 6
meters from the remote control sensor and within 60°
horizontally and 40° vertically of the front of the unit. The
operating distance may vary according to the brightness
of the room.
Note:
• Make sure that there is no obstacle between the
infrared remote sensor of the unit and remote control. If
you install the unit on rack, etc.., the remote controllable
range may decrease depending on the thickness or
colour of glass door of rack.
• Do not expose the infrared remote sensor to
direct sunlight or other strong light, such as inverter
fluorescent light.
CD Microsystem