Eco-Power/Standby Features; Setting The Clock; Adjusting The Volume; Sound Quality - VIETA VH-MS470BT User Manual

ECO-Power/Standby Features

Powering ON/OFF
When you insert the AC Power cable into a wall outlet,
the unit will be in clock mode.
• Press the STANDBY
The word "HELLO" will show in the display.
• Press the STANDBY
to clock mode. The words "BYE BYE" will scroll across
the display.
Switching the system to ECO Power/Clock
mode
Press and hold the STANDBY
or more to switch to ECO Power Standby or normal
clock mode.
* ECO Power clock mode
The clock will not be displayed. Press the CLOCK button
to display the clock on the LCD.
* Normal clock mode
The clock display on the LCD.
Note:
1. If the unit is idle for more than 90 seconds in clock
mode, it will automatically switch to ECOPower
mode.
2. If the unit is idle for more than 15 minutes in normal
mode, it will automatically switch to ECOPower
mode.

Setting the Clock

• Setting the Clock Manually
1. Set the unit in standby mode.
2. Press and hold the Clock button, the VFD will display
CLOCK SET and CLOCK 24 begins to blink.
3. Press the VOL+/- button on the remote control on the
front panel of unit to select 12/24 mode (time format),
the hour digits begin to blink.
4. Press the VOL+/- button on the remote control on the
front panel of unit to set the hour, press the Clock button
to confirm.
5. Set the minute with the VOL+/- button
6. Press the Clock button, the built-in clock starts
operating.
Note:
• If the clock setting is idle for more than 90 seconds,
the clock setting mode will be cancelled.
• If a power failure occurs or the unit is disconnected
from the mains, the clock setting will be lost.
30
button to switch the unit on.
button to switch the unit back
button for 2 seconds
• Setting the Clock Automatically
When the RDS station display the time, press and hold
the "display" button on the remote control, the clock will
automatically sync time of RDS.
• Display the Clock
In ECO power mode, press the Clock button.

Sound Quality

Adjusting the Volume

To increase or decrease the volume, rotate the
VOLUME + knob on the unit or press the VOL +/-
buttons on the remote control.

Adjusting the Super Bass

You can reinforce the bass sound to maintain rich, full
bass at low volume.
Press the S-BASS button on the remote control to get
the effect, the word "DBB" will lit on the front panel.
Press the S-BASS button again to cancel the effect.

Adjusting the Bass

Rotate the BASS knob clockwise or counter clockwise
on the Amplifier to adjust the intensity of the bass output
sound.
Adjusting the Treble
Rotate the TREBLE knob clockwise or counter clockwise
on the Amplifier to adjust the intensity of the treble
output sound.
Controlling the Loudness
This unit has a loudness function, which can
automatically increase the bass sound effect at low
volume.
It can also increase the bass sound effect at high
volume, but it will be relatively less when it is at high
volume. Press the Loudness button on the remote
control to obtain the loudness function, the icon
" " will display on the front panel, press again will
disappear.
Presetting Equalizer
You can adjust the sound reproduced simply by
choosing from 5 preset equalizers. Press the P-EQ
button repeatedly to scroll through the following options:
Changing the Front Panel Darkness
This unit has three brightness levels for you to adjust the
clock display. Press the DIM button on the front panel
or the remote control repeatedly to choose the desired
brightness.
CD Microsystem