Table of Contents
Advertisement
Installation of Batteries in the Remote Control
1. Remove the battery compartment cover.
2. Insert two batteries (size AAA) correctly, so that the + and - polarities match the polarity diagrams in
the battery compartment.
*
About half a year of normal operation can be expected when using standard batteries.
*
When the batteries are exhausted, the remote will not function. Replace both batteries at the same
time with new ones.
*
Don't mix old and new batteries.
*
Don't mix different types of batteries.
*
When the unit is not used for a long period of time, remove the batteries to avoid damage caused by
battery leakage and corrosion.
*
The batteries (battery pack of batteries installed) shall not be exposed to excessive heat such as
sunshine, fire or the like.
Turning the Power On and Off
You can use all the functions on the panel of the unit or the remote control after connecting to power
supply (called Standby Mode).
Note: In standby mode, if you don't use any function of the unit for 15 minutes, the unit will switch to
ECO power standby mode automatically.
Turning the System On
Press the standby button (
Caution: When turning the system on, the system will continue in the mode it was in when it was turned
off last time.
Turning the System Off
Press the standby button (
Caution: Be sure to unplug the power cord from the outlet when the system is not in use for an
extended period of time.
Button Functions
General Operate
In power on mode, press the DVD function button (
(You can also operate the key "
Press the open/close button (
while pressing the disc's center hole lightly (with the printed frontad). Press this button
again to close the disc tray, the unit will read the disc and the disc type will display on the TV
screen. The disc should play automatically.
(You can also operate the key "
Note: If a power failure occurs, you can open or close the disc door while pushing the disc
door.
291D-e(#EJS89S,re-11).p65
) to turn the system on from standby mode.
STANDBY
) again to turn the system off and go to standby mode.
STANDBY
FUNCTION
) to open the disc door and place the disc on the disc tray
K
" on the panel of unit.)
K
- 8 -
8
) to select DVD function.
DVD
" on the panel of unit.)
2009-9-29, 17:48
Advertisement
Table of Contents
