Ice Tray (Optional); Thermostat; Illuminating Lamp And Replacement; Placement - INVENTOR INVMS212A User Manual

Pro per use of re fri gera to rs
Ic e tr ay (optio nal)
Water line
Thermosta t
The temperature selector knob is located on the right hand side wall of the refrigerator interior
Setting"Off"：UnitOff
Setting"Min"：Less Cool Temperature
Setting"Med"：Normal Operation(adequate for most situations)
Setting"Max"：Coolest Temperature
During high ambient temperatures e.g. on hot summer days. It may be necessary to set the
thermostat to the Coolest setting(positionMax).This may cause the compressor running
continuously in order to maintain a low temperature in the cabinet.
For the first time you install your refrigerator, set the thermostat knob at "Med".
Give your refrigerator time to cool down completely before adding food. It is the best to wait
24 hours before adding food. The thermostat knob controls the temperature. When the
thermostat control knob is set to OFF, the refrigerator will not be running.
Illu min atin g la mp and repla cement
lamp cover
Pla cement
Sta rt
The ice tray is used for making ice. Boiled water
injected to four-fifths of the capacity shall be placed
in the refrigerating chamber for about a few hours
before forming solid ice, twist the ice tray to separate
it from ice.
Do not bend the ice tray to avoid breakage.
Illuminating lamp parameter: MAX15W
Lighting lamps replacement:
First unplug the refrigerator-freezer.
As specified in the drawing, first remove the lighting lampshade
on the arrow, and then replace the bulb.
Before using the
refrigerator, remove all
packaging materials
including bottom
cushions and foam pads
and tapes inside the
refrigerator, tear off the
protective film on the door
and the refrigerator body.
Keep away from heat and
avoid direct sunlight. Do not
place the freezer in moist or
watery places to prevent rust
or reduction of insulating
effect.
The refrigerator shall stay
for half an hour before
connecting 220-240V/50Hz
power when it is firstly
started.
The refrigerator shall run
2 to 3 hours before loading
fresh or frozen foods; the
refrigerator shall run for
more than 4 hours in
summer in advance
considering that the
ambient temperature is
high.
5
The refrigerator is placed in a
well-ventilated indoor place;
the ground shall be flat, and
sturdy (rotate left or right to
adjust the wheel for leveling if
unstable).
The top space of the refrigerator
shall be greater than 30cm, and
the distances from both sides and
backside shall be more than 10
cm to facilitate the opening and
closing and heat dissipation.
Wipe the refrigerator inside and
outside with warm moist rag (add
a small amount of detergent in the
warm water and wipe clean finally
with clean water).
545mm
Please leave enough space to
ensure feasible opening and
drawer removal.
Dimensions shown are for
reference only.
1000mm