Set Up Main Unit; Set Up Remote Sensor - Oregon Scientific I600 User Manual

Data signal reception indicator:
ICONS
continuous display
flashing
NOTE Clock reception and data display is dependent
on the successful transmission of data from PC and
Communications Hub. If
UP and DOWN together on the Main Unit.
The equipment is to be supplied from an identified USB
port complying with the requirements of Limited Power
Source.

SET UP MAIN UNIT

1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities and
press RESET.
3. Main Unit will begin receiving data
NOTE Batteries should not be exposed to excessive
heat such as sunshine or fire.

SET UP REMOTE SENSOR

NOTE Once display on Main Unit no longer shows
dashed lines (apart from outdoor sensor area), you can
MEANING
Data transfer is successful
Data transfer in progress
Weak signal. Data transfer
incomplete
is displayed, press and hold
begin installing the remote sensor.
1. Slide open the battery door.
2. Select channel.
3. Insert the batteries, matching the polarities (+ / -)
and press RESET.
4. Close the battery door.
5. Secure the sensor in the desired location using the
wall mount bracket.
NOTE USB Communications Hub will search only for
already registered sensor or new sensor reset within
last 30 minutes. To register a new sensor, reset sensor
prior to search.
For best results:
• Place the sensor within 100 m (300 ft) of the USB
Communications Hub and main unit.
• Position the sensor so that it faces the USB
Communications Hub and main unit, minimizing
obstructions such as doors, walls and furniture.
• Place the sensor out of direct sunlight and moisture.
• Place the sensor in a location with a clear view to
8