Main Unit Set Up; Data Transmission - Oregon Scientific RMS600A User Manual

3. Insert the battery, matching the polarities (+ / -). See
FIG 3.
4. Press RESET after each battery change.
5. Close the battery door.
NOTE
Install battery in the remote sensor before the main
unit.
6. Initiate a sensor search on the main unit to start
receiving temperature / humidity data from the sensor.
7. Secure the sensor in the desired location using the wall
mount hole.
NOTE
Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.

MAIN UNIT SET UP

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG
2).
3. Press RESET after each battery change.
P/N: 086L005521-019 REV1
6/92
NOTE
Batteries should not be exposed to excessive heat such
as sunshine or fire.
LOCATION
Clock / alarm area
Outdoor sensor area

DATA TRANSMISSION

To search for a sensor:
Press and hold + MODE.
The remote sensor reception icon will show the following
status:
ICON
Main unit is searching for sensor(s).
A channel has been found.
The sensor cannot be found.
TIP
The transmission range may vary depending on many
factors. You may need to experiment with various locations
to get the best results.
4
MEANING
Main unit batteries low
Sensor batteries low
DESCRIPTION