Fm/Am Radio; Usb And Network - Yamaha RX-A1010 Owner's Manual

FM/AM radio

Problem
FM radio reception is weak or noisy.
AM radio reception is weak or noisy.
Radio stations cannot be selected
automatically.
AM radio stations cannot be registered
as presets.
This unit does not receive HD Radio
signals.
iTunes Tagging data cannot be
transferred to an iPod.

USB and network

Problem
This unit does not detect the USB
device.
Folders and files in the USB device
cannot be viewed.
The network feature does not function.
Cause
There is multi-path interference.
Your area is too far from the FM station transmitter.
The noises may be caused by fluorescent lamps, motors,
thermostats, or other electrical equipment.
Your area is too far from the FM station transmitter.
The AM radio signal is weak.
"Auto Preset" has been used.
This unit is in the monaural reception mode.
The iPod is connected to this unit via an iPod dock "YDS-10" or an
iPod wireless system.
Cause
The USB cable connecting this unit and USB device is not
compliant with USB 2.0.
The folder structure not supported by this unit is applied.
The network parameters (IP address) is not obtained properly.
Remedy
Adjust the FM antenna height or orientation, or place it in a different location.
Press MODE to select "Mono" (monaural reception) (p.55).
Use an outdoor FM antenna commercially available. We recommend using a
sensitive multi-element antenna.
It is difficult to completely eliminate noise. It may be reduced by using an outdoor
AM antenna commercially available and properly grounding. Connect it to the
ANTENNA (AM/GND) jack together with the supplied AM antenna.
Select the station manually (p.55).
Use an outdoor antenna commercially available. We recommend using a
sensitive multi-element antenna.
Adjust the AM antenna orientation.
Select the station manually (p.55).
Use an outdoor AM antenna commercially available. Connect it to the ANTENNA
(AM/GND) jack together with the supplied AM antenna.
"Auto Preset" is for registering FM radio stations and HD Radio stations only.
Register AM radio stations manually (p.55).
Press MODE to select "Auto" (p.55).
The iPod dock "YDS-10" and iPod wireless system do not support tag data
transfer. To transfer tag data, use the USB cable supplied with the iPod, or an
iPod dock "YDS-12" or "YDS-11".
Remedy
Use a USB cable compliant with USB 2.0.
This unit supports folder hierarchies of up to 8 levels and up to 500 items (total of
files and subfolders) per folder. If necessary, modify the folder structure on your
USB device.
Enable the DHCP server function on your router and set "DHCP" in the "Setup"
menu to "On" on this unit (p.111). If you want to configure the network parameters
manually, make sure using an IP address which is not used by other network
devices in your network (p.111).
129
En