Yamaha RX-A1010 Owner's Manual page 107

❑ Bass Cross Over
Sets the lower limit of low-frequency component produced from speakers of which the
size is set to "Small". A frequency sound lower than the specified value will be
produced from the subwoofer or front speakers
Settings
40Hz, 60Hz, 80Hz (default), 90Hz, 100Hz, 110Hz, 120Hz, 160Hz, 200Hz
• If the volume and cross-over frequency are adjustable on your subwoofer, set the volume to half and cross-
over frequency to maximum.
■
Distance
Sets the distance between each speaker and listening position so that sounds from the
speakers reach the listening position at the same time. First, select the unit of distance
from "Meter" or "Feet".
Choices
Front L, Front R, Center, Surround L, Surround R, Surround Back L, Surround Back R, Front
Presence L, Front Presence R, Subwoofer
Setting range
0.30m ~ 24.00m (1.0ft ~ 80.0ft) *0.05m (0.2ft) steps
Default
3.00m (10.0ft)
■
Level
Adjusts the volume of each speaker.
Choices
Front L, Front R, Center, Surround L, Surround R, Surround Back L, Surround Back R, Front
Presence L, Front Presence R, Subwoofer
Setting range
-10.0dB ~ +10.0dB (0.5dB steps)
Default
0.0dB
■
Parametric EQ
Adjusts sound quality of tone with an equalizer.
❑ PEQ Select
Selects a type of equalizer to be used.
Settings
Select this when you want to adjust the equalizer manually.
Manual
For details, see "Manual equalizer adjustment".
YPAO:Flat Adjusts individual speakers to achieve the same characteristics.
Adjusts individual speakers to achieve the characteristics same as the
YPAO:Front
front speakers.
YPAO:Natural Adjusts all speakers to achieve a natural sound.
Through Does not use the equalizer.
• "YPAO:Flat", "YPAO:Front" and "YPAO:Natural" are available only when the measurement results of "Auto
Setup" have already been saved (p.40).
❑ PEQ Data Copy
Copies the parametric equalizer values acquired with "Auto Setup" (p.40) to the
"Manual" fields for fine adjustment.
Choices
Flat > Manual Copies the "Flat" values acquired with "Auto Setup".
Front > Manual Copies the "Front" values acquired with "Auto Setup".
Natural > Manual Copies the "Natural" values acquired with "Auto Setup".
■
Manual equalizer adjustment
1
Set "PEQ Select" to "Manual" and press ENTER.
2
Use the cursor keys to select a speaker and press ENTER.
3
Use the cursor keys to select an item and press ENTER.
Band / Gain: You can select a center frequency from the preset 7 bands and adjust the gain.
Freq. / Gain: You can adjust the center frequency of the selected band and adjust the gain.
Q / Gain: You can adjust the Q factor (bandwidth) of the selected band and adjust the gain.
Clear: Restores the default settings for the selected speaker.
106
En