Cutting Discs - Ninja BL492 series Owner's Manual

CUTTING DISCS

If your unit comes with this accessory, read the following instructions. For a list of what is included with this model, refer to inside flap of the box.
ASSEMBLY OF
ASSEMBLY:
THE CUTTING
WARNING: NEVER LEAVE THE APPLIANCE
UNATTENDED WHILE IN USE.
DISCS
CAUTION: Cutting discs are sharp. When
handling the cutting discs, always hold by
the rim of cutting discs and keep fingers
away from cutting edges.
IMPORTANT: MAKE SURE THE MOTOR
BASE IS PLUGGED IN FOR USE.
IMPORTANT: Use only the LOW setting
when using either cutting disc.
NOTE: Cutting discs must be used with the
feed chute lid.
1 Place the motor base on a clean, dry, level
surface such as a counter or tabletop. Press
down on the motor base to make sure that the
suction cups adhere to the counter or tabletop.
2 Secure the bowl onto the motor base. Align and
lower the Processor Bowl onto the motor base.
Handle should be aligned slightly to the right of
the LOCK symbol on the motor base.
3 Rotate the Processor Bowl clockwise until it
locks in place (you will hear a click when the
lock is engaged).
1 2
®
4 Holding the spindle by the shaft, place it onto
the drive gear inside the bowl. Ensure that it is
seated properly and is standing upright.
5 Use the spindle hole to grasp the selected disc
and place it over the spindle.
6 The Slicing/Shredding disc is reversible. Use
the side labeled "Slicer" for slicing. Carefully flip
the disc over to the side labeled "Shredder" for
shredding.
7
Holding the Lid from the feed chute, place it on
top of the bowl and turn clockwise aligning the
arrow ( ) located on the lid with the arrow ( )
located on the bowls handle.
8 Plug the power cord into the electrical outlet.
Select LOW on the control panel. The disc will
begin spinning.
9 Add the food that you want to slice, shred or
grate through the feed chute on the lid. Use
the two-part food pusher to help guide the
food through the feed chute. The middle piece
of the food pusher is removable to use for
smaller ingredients.
w w w . s h a r k n i n j a m a n u a l s . c o m
10 The LOW setting will run for 30 seconds, or
when finished, press the START/STOP button
and wait for the disc to stop turning. Press the
button on the feed chute lid located near the
handle to unlock and turn the lid anticlockwise.
Lift to remove from the processor bowl. Using
the spindle hole, carefully lift the disc out of the
bowl and remove the spindle.
11 Make sure that the motor base is unplugged
when not in use.
12 To release the motor base from the counter or
tabletop, place your fingers under the sides of
the black paddles on the sides of the base and
lift up to release suction cup feet.