Using The Discs - Ninja Ultima BL820 Important Safety Instructions Manual

Assembly and Use for the 64 oz. Bowl - cont.
13 TOLL FREE:
Fig. 23
1-877-646-5288

USING THE DISCS

IMPORTANT: Use only the "DOUGH/DISC" setting
when mixing dough or using either disc.
IMPORTANT: Use ONLY the Feed Chute Lid when
using the discs.
1 Place the motor base on a clean, dry, level surface
such as a counter or table top. (Fig. 23)
2 Secure the bowl onto the motor base.
3 Place the disc gear shaft inside the bowl.
4 Use the finger holes to grasp the selected disc and
place it over the gear shaft.
5 Place the feed chute lid on the bowl and turn
clockwise to lock in place. (Fig. 23)
6 Plug the power cord into the electrical outlet and
press up on the power toggle ( ) to turn the power
"On".
7 Turn the variable speed dial to 10 (Dough & Discs).
8 Press the Start/Stop/Pulse toggle up to have the
discs start spinning.
9 Add the food that you want to slice, shred or grate
through the feed chute on the lid. (Fig. 23)
10 The food pusher has two parts. Use the assembled
food pusher to push the food through the feed
chute. (Fig. 23) If the food to be sliced is of a small
diameter, use the small feed chute by twisting the
food pusher and removing the inner tube. Feed the
food to be sliced through the smaller chute.
TIP: Twist the inner tube of the food pusher counter
clockwise and pull to remove it from the food
pusher.
11 When finished, press the Start/Stop toggle up to
stop the discs and then press the power toggle
down to turn the appliance off. Remove the lid.
Using the finger holes, carefully lift the disc out of
the bowl.