Installation Places; Indoor Unit; Outdoor Unit; Stallation - LG MFL62541004 Installation Manual

INSTALLATION PLACES

Indoor unit

- The place shall easily bear a load exceeding
four times the indoor unit's weight.
- The place shall be able to inspect the unit as
the figure.
- The place where the unit shall be leveled.
- The place shall allow easy water drainage.
- The place shall easily connect with the

outdoor unit.

- The place where the unit is not affected by
an electrical noise.
- The place where air circulation in the room
will be good .
- There should not be any heat source or
steam near the unit
Top view
(unit: mm)
Inspection hole
(600 x 600)
Control box
Front
Front view
(unit: mm)
* Suitable dimension "H" is necessary to get
a slope to drain as figure.
Outdoor unit
- If an awning is built over the unit to prevent
- Ensure that the spaces indicated by arrows
- Do not place animals and plants in the path
- Take the air conditioner weight into account
- Select a place so that the warm air and noise
H=200 or more
INSTALLATION PLACES
direct sunlight or rain exposure, make sure
that heat radiation from the condenser is not
restricted.
around front, back and side of the unit.
of the warm air.
and select a place where noise and vibration
are minimum.
from the air conditioner do not disturb
neighbors.
More than
300
O U
O U O U
T D
T D T D
O O
O O O O
U n
R R
R
U n U n
i t
i t i t
F e
n c e
o b
o r
s t a
c l e
s
7
More than
More than More than
300
300 300
More than 600
More than 700
Unit : mm