Table of Contents
Advertisement
Damper Controller
- Open the cover of indoor unit control box and damper controller(Figure 1)
- Assemble the damper controller to cover which is seperated.
- Connect the lead wires between main PCB and damper controller.(Figure 2)
- Connect the power cord to damper controller and actuator.(Figure 2)
- Assemble the damper controller to indoor unit and then assemble cover of damper controller.
- Set the slide switch in the wired remote contorller as "1" positon.(Figure 3)
- Refer to damper controller Installation manual for detailed installation metheod.
Figure 1
(It is possible to use 2-position control actuator(on/off) or 3-position control actuator(on/off).)
Remote controller
Figure 3
ACCESSORY INSTALLATION GUIDE
Damper controller
Power
supply
Actuator Actuator Actuator Actuator
Figure 2
Zone type selection
1
1. Zone new
2
2. Zone old
S/W 1
33
Indoor PCB
Advertisement
Table of Contents
