Installation Places; Indoor Unit; Outdoor Unit - LG B30AWYN7G5 Installation Manual

INSTALLATION PLACES

Indoor unit

- The place shall easily bear a load exceeding
four times the indoor unit's weight.
- The place shall be able to inspect the unit as
the figure.
- The place where the unit shall be leveled.
- The place shall allow easy water drainage.
- The place shall easily connect with the

outdoor unit.

- The place where the unit is not affected by
an electrical noise.
- The place where air circulation in the room
will be good .
- There should not be any heat source or
steam near the unit
Top view
(unit: mm)
Inspection hole
(600 x 600)
Control box
Front
Front view
(unit: mm)
H=200 or more
* Suitable dimension "H" is necessary to get
a slope to drain as figure.
INSTALLATION PLACES
Outdoor unit
- If an awning is built over the unit to prevent
direct sunlight or rain exposure, make sure
that heat radiation from the condenser is not
restricted.
- Ensure that the spaces indicated by arrows
around front, back and side of the unit.
- Do not place animals and plants in the path
of the warm air.
- Take the air conditioner weight into account
and select a place where noise and vibration
are minimum.
- Select a place so that the warm air and noise
from the air conditioner do not disturb
neighbors.
More than
300mm
F e
n c e
o b
o r
s t a
c l e
s
9
More than More than More than
300mm 300mm 300mm
More than 600mm
More than 700mm