REMOVAL OF WHEELS
Front wheel
(fig. 21)
To remove the front wheel, proceed as follows
:
•
Set the vehicle up on the center stand and
place a stand under the engine crankcase to keep
the wheel up from the ground.
•
Undo screws «A» securing the caliper to the
right fork cover and from this remove caliper «8»
complete with its piping.
•
Undo the spindle securing nut
«C»
on the L/H
side.
•
Undo the screws «E» securing the fork covers
to wheel spindle.
•
Withdraw spindle «F» paying attention to the
mounting position of spacers «0» and «G».
•
Take out the braking disc (on the right side of
the wheel) from the caliper fitted on the R/H fork
cover. Take off the wheel from the fork legs. The re-
assembly operation is a reversal ofthe dismantling
one.
Rear wheel
(fig. 22)
To remove the rear wheel from the swing arm and
the drive box, proceed as follows:
•
Set up the bike on the center stand.
•
Undo nut «A» with washer «8» on the spindle,
rear drive box side.
•
Loosen spindle bolt «0» on fork arm.
•
Withdraw spindle «C» from the drive box, the
hub, and the swing arm.
•
Take out braking disc from caliper «E».
21
•
Remove the plate assembly fitting the caliper
31