23. When installing electrical equipment at wooden building of metal lath or wire lath, in accordance with electrical facility standard, no electrical

contact between equipment and building is allowed. Insulator must be installed in between.

24. This installation may be subjected to building regulation approval applicable to respective country that may require to notify the local authority

before installation.

25. Any work carried out on the Mono bloc unit after removing the front panel which is secured by screws, must be carried out under the

supervision of authorized dealer and licensed installation contractor.

26. This unit must be properly earthed, the electrical earth must not be connected to a gas pipe, water pipe, the earth of a lightening rod or a

telephone. Otherwise there is a danger of electrical shock in the event of an insulation breakdown or electrical earth fault in the Mono bloc unit.

27. When replace refrigeration circuit components, confirm on usage of specified refrigerant type. Using of refrigerant other than the specified type

may cause product damage, burst and injury etc.

28. Do not add or replace refrigerant other than the specified type. Equipment may damage or deteriorate in safety due to usage of other

refrigerant.

1. Do not install the Mono bloc unit in areas where there is a risk of flammable gas leakage. There is a risk of fire if flammable gas

accumulates near or around the Mono bloc unit.

2. Do not release refrigerant during piping work for installation, re-installation and during repairing a refrigeration parts. Take care of the

liquid refrigerant, it may cause frostbite.

3. Make sure the power supply cord does not contact with hot part (i.e. water piping). High temperature may cause insulator of power

supply cord damage hence electrical shock or fire.

4. Do not touch the sharp aluminum fins or edges of metal parts.

If you are required to handle sharp parts during installation or servicing, please wear hand glove.

Sharp parts may cause injury.

5. Do not apply excessive force to water pipes that may damage the pipes. If water leakage occurs, it will cause flooding and damage to

other properties.

6. Carry out drainage piping as mentioned in installation instructions. If drainage is not perfect, water leakage may happen and may cause

damage to properties of the user.

7. The piping installation work must be flushed before the Mono bloc unit is connected to remove contaminants. Contaminants may damage the

Mono bloc unit components.

8. Select an installation location where it is accessible for maintenance.

9. Power supply connection to Mono bloc unit.

 Power supply point should be in easily accessible place for power disconnection in case of emergency.

 Must follow local national wiring standard, regulation and this installation instruction.

 Strongly recommended to make permanent connection to a circuit breaker. It must be a double pole switch with a minimum 3.0 mm gap.

- Use approved 30A circuit breaker for power supply 1

- For electrical heater connection to main for power supply 2 (either

Use approved 15A/16A circuit breaker (Backup Heater only)

Use approved 30A circuit breaker (Backup Heater + Booster Heater)

10. Ensure the correct polarity is maintained throughout all wiring. Otherwise, it will cause electrical shock or fire.

11. After installation, the installer is obliged to verify correct operation of the Mono bloc unit. Check the connection point for water leakage during

test run. If leakage occurs, it will cause damage to other properties.

12. Installation work.

Four or more people are required to carry out the installation work. The weight of Mono bloc unit might cause injury if carried by less than four

people.

CAUTION

)

Table of Contents