Installing The Canopy Housing; Operating Instructions - Rotary Switch - Fanimation PL8018 Series Owner's Manual

• Attach wall control unit to outlet box using the two
6-32 screws provided.
• Attach face plate to the wall control.
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Securely attach the Canopy Housing to the Hanger
Bracket using the two previously removed screws.
(Figure 1)
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
1. Select the desired airflow located on the fan motor
assembly by rotating clockwise. (Figure 1)
• 1st position – high fan speed
• 2nd position – medium fan speed
• 3rd position – low fan speed
• 4th position – fan off
How to Wire Your Wall Control

Installing the Canopy Housing

Operating Instructions – Rotary Switch
10
Figure 2
Figure 1
Figure 1