Installing The Remote Control Unit - Pioneer DEH-P9200R Installation Manual

Installation
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 12)
Frame
Insert the release pin into the hole in
the bottom of the frame and pull out
to remove the frame.
(When reattaching the frame, point
the side with a groove downwards
and attach it.)
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 13) (Fig. 14)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fit-
ted), and tighten the screws at 2 places on each side. Use
either binding screws (5 × 6 mm) or flush surface screws
(5 × 6 mm), depending on the shape of the screw holes in
the bracket .
10
Fig. 12
12
Factory radio mounting bracket
<ENGLISH>

Installing the Remote Control Unit

Fitting the Remote Control Unit
Precaution:
• Press the remote control unit onto the mounting base until it clicks into place.
Fitting horizontally (Fig. 15)
Fig. 13
11
Screw
Dashboard or Console 13
Fig. 14
Installation Using the Mounting Base
Precaution:
• To avoid it being a hindrance to driving, always install the remote control unit to the passenger's
• Install the mounting base so that the remote control unit is slanting upwards at an angle when fitted.
Fitting vertically (Fig. 16)
• Before using double-sided tape, clean off any dirt on the surface to which the double-sided tape is
Fig. 15 Fig. 16
<ENGLISH>
side – not the driver's side.
to be attached.
Mounting Base
Double-sided tape
Not used
Used
Passenger seat
Fig. 17