Installation; Installing The Remote Control Unit - Pioneer AVH-P4950DVD Installation Manual

Installation

Note:
• Check all connections and systems before final
installation.
• Do not use unauthorized parts. The use of
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons
or (iii) impair the driver's ability to safely operate
the vehicle.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit
is installed at an angle of less than 30°. (Fig. 12)
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
• The cords must not cover up the area shown in the
figure below. This is necessary to allow the
amplifires to radiate freely. (Fig. 13)
Do not close this area.

Installing the remote control unit

When not using the remote control
unit, secure it with velcro tape to pre-
vent it from moving.
• Thoroughly wipe off the surface
before affixing the velcro tape.
30°
Fig. 12
Fig. 13
Remote control unit
Velcro tape (small)
(hard)
Velcro tape (small)
(soft)
Fig.14
12